Both RAID 60 Groups Are Degraded and No Array Is Found
When both lower RAID 6 groups are degraded and the RAID 60 virtual disk is gone, the controller cannot assemble the compound array from the member state it sees. Recovery begins by treating each lower group as its own reconstruction problem.
Do not recreate the RAID 60, force either group online, or start parallel rebuilds. Preserve every original and replacement member from both groups.
What this condition means
Each lower group may have different failures, member histories, and readable coverage. One group cannot be assumed healthy simply because more of its drives respond.
Only after both lower groups are reconstructed can the stripe across them be tested for the expected capacity, filesystem, and data.
What to record
- Expected number of groups, members per group, and total capacity
- Bay, serial number, size, and displayed status of every member
- Which members belong to each lower group if known
- Failure, replacement, and rebuild sequence for both groups
- Controller, cache, enclosure, power, and firmware events
What not to do
- Recreate the compound array with remembered settings
- Force either lower group online
- Replace several reported members at once
- Discard members marked failed or foreign
- Run filesystem repair before both groups are reconstructed
How ADR evaluates it
ADR identifies and protects the members, then reconstructs each lower RAID 6 group independently using the best available sources.
The recovered groups are joined at the top layer and checked against the expected filesystem and priority data before output is accepted.
What happens next
The missing virtual disk does not have to be restored on the original controller. ADR can work from the complete member set and rebuild the two layers in a controlled recovery environment.